condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com model pwr output #1 output #2 output #3 output #4 pci 204-1203 200 +5v @ 30a* +3.3v @ 20a* +12v @ 5a** -12v @ 5a** standard pci series the pci 204 power supply series provides simultaneous high currents on both 5 v and 3.3 v outputs. the load may be shifted between outputs. for example: the pci 204-1203 may be loaded at +5 v @ 25 a and 3.3 v @ 5 a, or 5 v @ 10 a and 3.3 v @ 20 a, or any other combination of loads within the maximum ratings. similarly the 12 v may be loaded in any combination not exceeding maximum ratings. the pci series provides a single solution as system configurations proliferate, thereby reducing cycle time and cost. 200 watts power factor corrected multiple output PCI-200 featuring: dual main outputs flexible ratings 5 v ?eep alive?bias output universal ac input 0.99 typical power factor remote sense on main outputs dc power good and ac power fail true remote inhibit high-current bus bars * combined rating, sum of output currents of outputs #1 & #2 equals 30 a. ** combined rating, sum of output currents of outputs #3 & #4 equals 5 a.
condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com specifications: input ac input: 90 - 264 vac continuous range, 47 to 63 hz. internally fused for 4 a. power factor: 0.99 typical at full load. meets en61000-3-2. inrush: cold start ac current limited to 16 a. at 115 vac, 30 a. at 230 vac. limited by thermistor. brownout protection: holds regulation to 85 vac. holdup time: 16 ms minimum. efficiency: 70% typical at full load nominal line. ac power fail: provides ttl ??5 ms before output goes out of regulation band upon loss of input power. output adjustability: + / - 5% line & load reg: + /- 1% over ac input range and minimum to maximum load. minimum load: 10% on main to insure regulation of aux outputs. ripple & noise: less than 1% p-p or 100 mv, which ever greater. remote sense: (outputs #1, and #2) compensates for 250 mv total line drop. open sense lead protection. temperature coefficient: 0.02% per degree c. transient response: output voltage returns to within 1% in less than 500 ? for a 25% load change. peak transient does not exceed 3%. overload protection: all outputs are protected against overload and short circuit. automatic recovery upon removal of fault. overvoltage protection: output #1 protected against power supply induced overvoltage condition. factory set to 136% maximum. other outputs inherently voltage limited by design. remote inhibit: contact closure to negative sense line or a ttl ??(open collector) turns off dc outputs. reverse voltage: protected against reversed voltage up to supply current ratings. dc power good: provides ttl ??(open collector) when output #1 above 4.6v. aux output: provides 5 v + / - 5% @ 100 ma bias output, which is present whenever power supply has input power. environmental thermal protection: shuts down power supply if heatsink temperature exceeds 82 c. temperature range: 0 c to 50 c at full ratings. safety agencies: approved to ul 1950; csa 22.2 # 234 (950); tuv en60950, class 1 selv; ce 72/23/eec/93/68eec (low voltage directive). output isolation: isolated form ground 50vdc. conducted rfi: meets fcc part 15, subpart j class a, and cispr 22 class a. cooling: 30 cfm required to achieve full ratings. options: consult factory for available options. 200 watts 8.09? 5? 2 PCI-200 function location notes connector output #1 terminal marked +5 main output bus bar #8-32 screw terminal marked rtn rtn (com) bus bar #8-32 screw output #2 terminal marked +3.3 +3.3 output bus bar #8-32 screw output #3 j1-5 + output amp p/n 1-6044-7 j1-6 +/- rtn (com) mates with: output #4 j1-7 - output function location notes connector remote sense j1-1 +5 sense see above j1-2 +3.3 sense j1-3 +3.3 sense rtn j1-4 +5 sense rtn dc power good j1-8 reference to com ac power fail j1-9 reference to com inhibit j1-10 reference to com aux output (+) j1-11 5v aux bias aux output (-) j1-12 5v aux bias rtn function 115 vac 230 vac connector j1-17 neutral line 2 amp p/n 1-60445-7 mates with: j1-15 line line 1 amp p/n 1-640426-7 ac input (90 - 264 vac continuous range) dc output status and control dimensions: inches millimeters PCI-200 2.0 lbs .9 kgs
|